Interlogix NX-4V2 User Manual Uživatelský manuál stáhnout pdf (Strana 14)

10 NX-4V2 LED Keypad User Manual

Adding and changing user codes

Your system must be Disarmed to add/change user codes.

1. Press [*]-[5].

2. Enter a “Master Arm/Disarm Code”.

3. The ready light will flash.

4. Enter the 2 digit. Always enter 2 digit such as [0] - [3] for user 3,.

5. Enter the new four (4) or six (6) digit “user code”. Note: To delete a user

code, enter [r]-[r]-[r]-[r] for a 4-digit code, or [r]-[r]-[r]-[r]-[r]-[r] for a 6-digit code.

6. The ready light will flash indicating you are back at Step 4 above. If the code

is rejected, the sounder will beep 3 times.

NOTE: To delete a user code, enter [∗]-[∗]-[∗]-[∗] for a 4-digit code, or [∗]-[∗]-

[∗]-[∗]-[∗]-[∗] for a 6-digit code.

7. The ready light will flash indicating you are back at Step 4 above. If the code

is rejected, the sounder will beep 3 times.

8. If another “user code” needs to be programmed, return to Step 5.

9. Press the [#] key while the ready light is flashing to exit the User Code

Programming Mode.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21

Žádné komentáře

Interlogix NX-4V2 User Manual Uživatelský manuál Strana 14