Interlogix Simon XT Tabletop Installation Manual Uživatelský manuál stáhnout pdf (Strana 31)

Chapter 3:

Simon XT TableTop Control Panel Installation Manual 25

2. Connect the four-conductor cable wires to the RJ31X.

3. Disconnect the green and red premises phone jack wires from the Telco block

and splice them to the four-conductor cable black and white (or yellow) wires.

Use weatherproof wire connectors for these splices.

4. Connect the four-conductor cable green and red wires to the Telco block TIP

(+) and red to RING (–) posts.

5. Connect the phone cord included with the panel to the RJ31X and the panel

LINE jack.

Figure 6: Full line seizure wiring with RJ31X

If a single phone is all that exists on the premises, full line seizure can be

accomplished without an RJ31X.

To wire a single phone, see Figure 7 and do the following:

1. Disconnect the phone from the premises phone jack and plug it into the panel

PHONE jack. This jack is disconnected automatically whenever the panel

reports.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 85 86

Žádné komentáře

Interlogix Simon XT Tabletop Installation Manual Uživatelský manuál Strana 31