Interlogix 1038T Series Uživatelský manuál stáhnout pdf

1038T Series Surface Mount Terminal

Magnetic Contacts

Installation Instructions

1. Run the system wiring to the switch location. System wires can be routed to either

end or side of the switch.

2. Clean the mounting surfaces with the alcohol pad provided.

3. Align and mount the switch base and the magnet base with either the tape or

screws provided. The arrow on the switch must point toward the magnet. See

Figure 1.

4. Strip, twist, and insert wires into the screw terminals. The wire should be between

the terminal body and nut. See Figure 2. Tighten screws.

5. If you are routing wires through the side of the switch cover, remove the appropri-

ate cutout from the cover.

6. Place the switch cover down over the center of the switch and slide it either left or

right until the cover snaps firmly into place. Repeat with the magnet cover.

FORM A 1038T

Voltage: 100 VAC/DC Max

Current: 0.5 A Max

Power: 7.5 W Max

* Gap Specifications are nominal and may vary ±20% due to

temperature. Gap Specifications are for switch to make.

Break distance is approximately 1.1 to 1.5 times make.

1031601 REV B 09/01

Figure 1

Figure 2

Magnet this side

Part Loop Electrical Gap Distance *

Number Type Configuration

1038T Closed NO 1"

Specifications

1 2

1038T Series Surface Mount TerminalMagnetic ContactsInstallation Instructions1. Run the system wiring to the switch location. System wires can be

Gap Distance Closed loopColorQuantity1038T-NUL¤CLISTEDUS1038T Series Surface Mount TerminalMagnetic Contacts 1" 1038

Žádné komentáře

Interlogix 1038T Series Uživatelský manuál