Interlogix Monitor XL Hardware Guide Uživatelský manuál Strana 47

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 66
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 46
22-0375 rev1.1 Monitor ISM/xL™ Hardware Guide 43
IP Module V3
Green DIR RX
RJ45
Female
Network
Connector
10BaseT
RJ45 Plug
& Cable to
Network
Network LEDS
Green
On = network
connection OK.
Flashing =
network
activity.
1
2
3
Dir RS485 A
Dir RS485 B
Dir Ground
Yellow DIR TX
Yellow SIP TX
Green SIP RX
Yellow Aux TX
Green Aux RX
Communcation LEDS
This connector can be used
to interconnect additional
panels for Director software
communications.
Not Used
Orange and blue wires can also be
used for “Direct Serial Configuration”.
See Sect. 4.5.2
LAN/WAN
Network
Discovery Mode
Program Button
Wire Connectors
(+) 12VDC
Orange
RS232 RX (SIP)
Yellow
RS485 B (Dir Sftwr)
Blue
RS232 TX (SIP)
Green
RS485 A (Director Sftwr)
Red
Black
( ) Neg. GND
These 4
mounting
holes for
new V3 brd
installation
adhesive
stand-offs.
These 3 mounting holes are adaptable to previous version 2 IP
Module adhesive stand-offs.
This is the position where the 4
th
hole for the previous version 2 IP
Module adhesive stand-off would be located but, could not be
accommodated. Cut the existing stand-off pin lower to support this
corner if replacing an existing V2 with a V3 board.
Not Used
V3 IP Module
P2
P3
Yellow
Jumper
Pins
Jumper Pins
Dir
: Refers to MONITOR ISM / AFx Director software communications.
SIP
: Refers to monitoring station communications (Security IP Receiver reporting).
Refer to the IP Connectivity Guide P/N 22-9059 for programming information.
Zobrazit stránku 46
1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 65 66

Komentáře k této Příručce

Žádné komentáře